Hayter Mowers T424 User Manual download pdf (Page 65)

953910KG141004

GRASS CUTTING FAULTS

1.65

1.65

Turning too tightly.

Mower sliding sideways

when travelling across face of a slope.

One end of cutterhead out

of ground contact caused by:

- Poorly routed hoses or wrongly

positioned hydraulic adaptors.

- Pivot pins seizing.

- Grass build up under cutterhead.

Forward speed too high.

Cylinder speed too slow.

Height of cut too low.

Cylinder is running slow.

Inconsistent height of cut setting on one

cylinder.

Raise/Lower position control not in float

position.

One end of cutterhead out

of ground contact caused by:

- Poorly routed hoses or wrongly

positioned hydraulic adaptors.

- Pivot pins seizing.

- Grass build up under cutterhead.

GRASS CUTTING FAULTS

Areas of uncut grass at

point of overlap between

cutting cylinders.

Ridge lines in the cut

across the direction of

travel over full width.

Ridge lines in the cut

grass across the direction

of travel over the cutting

width of one cylinder.

Step in cut grass height

at point of overlap

between cutting cylinders.

Reduce turning radius.

Mow up/down slope.

Reroute hoses/reposition

hydraulic adaptors.

Free off and grease pivot pins.

Remove grass.

Reduce forward speed.

Increase mower engine speed.

Raise height of cut.

Refer - TROUBLE

SHOOTING for remedy.

Check and readjust height of

cut setting.

Operate position control

to float position.

Reroute hoses/reposition

hydraulic adaptors.

Free off and grease pivot pins.

Remove grass.

FAULT POSSIBLE CAUSE REMEDY

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 85 86

Comments to this Manuals

No comments