Hayter Mowers T424 User Manual download pdf (Page 36)

953910KG141004

OPERATING THE MOWER

1.36

CUTTERHEAD POSITION CONTROL

The cutterheads may be raised or lowered using the bank of 3 lift control

levers.

To lower the cutterheads, operate the lift control levers in a downward

direction until locked in position 1. If the cutterhead drive switch is in the

‘ON’ position, the cylinder drive will engage when the cutterheads are

approximately 300mm above ground level.

IMPORTANT: PREVENT DAMAGE - The lift control levers must be

locked in position 1 while mowing. NEVER mow with the lift control

levers in position 2 (neutral).

To raise the cutterheads, operate the lift control levers in an upward direction

and hold in position 3. If the cutterhead drive switch is in the ‘ON’ position,

the cylinder drive will disengage when the cutterheads are approximately

300mm above ground level. Release the lift control levers when the

cutterheads are at the required height. The control levers will automatically

return to position 2 (neutral).

1. Down / float

2. Neutral

3. Raise

4. LH Wing or LH Wing+LH Front*

5. Centre+LH/RH Front or Centre*

6. RH Wing or RH Wing+RH Front*

*Depending on which lift configuration

is selected. Refer-Dual Lift Configuration

Control.

4A953B03A

DUAL LIFT CONFIGURATION CONTROL

The dual lift configuration control function enables the lift controls to be

used in two ways as follows:

Five gang mode, lift configuration (1):

Control switch in position 1

LH lift lever (3) controls LH wing cutterhead

Centre lift lever (4) controls LH front + centre + RH front cutterheads

RH lift lever (5) controls RH wing cutterhead

Three/five gang mode, lift configuration (2):

Control switch in position 2

LH lift lever (3) controls LH wing + LH front cutterheads

Centre lift lever (4) controls centre cutterhead

RH lift lever (5) controls RH wing + RH front cutterheads

With the LH and RH wing cutterheads locked in the fully raised

transport position.

Control switch in position 2

LH lift lever (3) controls LH front cutterhead

Centre lift lever (4) controls centre cutterhead

RH lift lever (5) controls RH front cutterhead

3D95301

4A953B03B

1. 5 Gang Mode

2. 3/5 Gang Mode

3. LH Lift Lever

4. Centre Lift Lever

5. RH Lift Lever

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 85 86

Comments to this Manuals

No comments

Hayter Mowers T424 User Manual Page 36

Comments to this Manuals

Related products and manuals for Lawnmowers Hayter Mowers T424